Where Downspout Water Should Go: Planning Drainage During a Roof Replacement

Downspout drainage, in short

Downspout drainage is the part of a roof’s drainage that happens on the ground. A gutter collects roof water along an eave and a downspout carries it down, but the downspout only moves the problem to its outlet. Where that water lands, and where it goes next, decides whether the system helps the house or harms it.

That makes the outlet the most important part of the design. A downspout that empties against a foundation, onto a path, or into a planter beside a wall concentrates a roof’s runoff on exactly the spot that should stay driest.

This article explains where downspout water should go on a Scottsdale property, what goes wrong when it does not, and why the outlets are best planned during a roof replacement. We handle drainage only as part of a replacement project, and the advice here is written with that in mind.

A roof concentrates rain into a few points

A roof collects rain over its whole area and delivers it to a handful of places. Without gutters it pours off the eaves and out of the valleys. With gutters it runs along the eaves and down the downspouts, so the entire roof’s runoff leaves through a few outlets.

Each outlet is therefore releasing far more water than would fall on that patch of ground on its own. In a light rain that hardly matters. In a monsoon burst, the water arriving at a downspout outlet can be enough to scour soil, pool against a wall or run across a path.

At the Scottsdale Municipal Airport weather station, NOAA’s 1991 to 2020 normals put about 0.90 inches of rain in July and 0.83 in August (NOAA NCEI). Much of that can arrive in single storms, which is when the outlets are tested.

That is why downspouts are a drainage design question rather than a fitting. Placing one at the nearest corner is easy. Placing it where its water does no harm takes thought.

Monsoon bursts and hard, dry ground

The National Weather Service office in Phoenix defines the monsoon season as June 15 through September 30 and names torrential rainfall among its hazards (NWS Phoenix). The NOAA Storm Events Database records 450 flash flood reports in Maricopa County between 2016 and 2025 (NOAA NCEI).

Those are reports rather than every event, but they reflect the pattern that shapes drainage here. Water arrives quickly and in quantity, often after months of dry weather, onto ground that does not absorb it fast.

Dry, compacted soil and hard surfaces send water sideways rather than letting it soak in. A downspout outlet on that kind of ground behaves less like a sprinkler and more like a hose: the water runs wherever the surface slopes, and if the surface slopes towards the house, so does the water.

Annual rainfall at the Scottsdale station is only 8.73 inches, which makes drainage easy to forget for most of the year and impossible to ignore in a storm.

Where downspout water should go

The goal is simple to state. Downspout water should be released onto ground that slopes away from the house, far enough out that it cannot run back, and somewhere it will not erode soil, flood a path or reach a neighbouring structure. It should leave the property’s drainage pattern better, not worse.

In practice that usually means releasing it beyond the immediate perimeter of the house, onto gravel, landscaping or a surface designed to carry water away. Splash blocks, extensions and drainage channels exist to move the outlet further from the walls and spread the flow.

Some properties carry downspout water underground to an outlet further away. That moves the release point, but an underground line can block with debris and silt, and a blocked line can back up at the downspout. Any buried system needs a way to be checked and cleared.

The right answer depends on the lot: its slopes, its surfaces, where water already flows in a storm, and what lies downhill.

Water in the wrong place does damage slowly

The most common problem is water released against or beside a foundation. Repeated soaking in the same spot can wet the soil under a footing, carry soil away, and stain or damage wall finishes close to the ground. The damage builds slowly and in the same place every storm.

Paths and entrances are the next. A downspout that empties onto a walkway or across a doorstep floods it in heavy rain, leaves grit and staining afterwards, and creates a slip hazard. A downspout at a garage door can send water straight under it.

Erosion is the third. Concentrated flow carves channels in soil and washes gravel out of beds, which then changes how water moves across the lot in the next storm. Over a few monsoon seasons that can redirect water towards the house without anyone noticing it happen.

Each of these is a design problem with the outlet rather than a fault in the gutter above it.

Equipment and finishes near the ground suffer too. Air conditioning units, pool equipment, electrical boxes and wooden gates placed beside a downspout take a drenching every storm. Stucco and paint close to grade stain and break down where water splashes back onto them, and that damage is usually mistaken for age rather than recognised as a drainage problem.

Signs your current outlets are in the wrong place

The evidence is usually visible after a storm, or in the marks the last one left. Look for washed-out soil or gravel at downspout outlets, channels running from them, staining low on walls near them, and water standing beside the foundation or across paths.

Look at where each downspout empties relative to the slope of the ground. An outlet on ground that tilts towards the house is releasing water that will come back. An outlet into a planter beside a wall is soaking that wall every time it rains.

Check for downspouts that have lost their extension or splash block, or that empty into a buried line that overflows at the top in heavy rain. Both turn a reasonable design into a poor one.

These are all things to observe from the ground. None of them requires climbing onto the roof or the ladder. Photographs taken during or straight after a storm are the most useful record, because by the next morning dry ground hides where the water actually went.

Low-slope roofs drain through scuppers and drains

Flat and low-slope roofs usually do not have gutters along their edges. They drain through scuppers, which are openings at the roof edge, or through internal drains, and the water from those then reaches the ground through a collector or a downspout. The same outlet question applies.

What happens on the roof itself is a separate matter. Water that collects on a low-slope roof instead of reaching its scuppers is a roof drainage problem, covered in our article on flat roof ponding and scuppers. This article covers what happens after the water leaves the roof.

Low-slope roofs also depend on their drains staying clear, which is part of routine upkeep. Flat roof maintenance that actually matters covers checking drains and scuppers before the monsoon season.

Whether a scupper or a downspout, the outlet still has to release water somewhere harmless.

Planning outlets during a roof replacement

A roof replacement is the natural time to plan downspout drainage, because the whole roof edge is being rebuilt. Gutters, if the house has them, come down and go back up. The positions of downspouts can be moved to where their water does least harm rather than where they happened to be.

That planning starts on the ground rather than on the roof. Where can water be released safely? Which corners of the house sit uphill? Where do paths and entrances run? Answers to those decide where downspouts belong, and the gutter layout follows.

We handle drainage only as part of a roof replacement. Standalone gutter, downspout or grading work is done by other contractors, and work on the ground beyond the outlets, such as regrading or landscaping, belongs to the specialists in that work.

What a replacement involves, including drainage improvements made during the project, is covered on our roof replacement in Scottsdale page.

Gutters and downspouts work as one system

A downspout is only as good as the gutter feeding it, and a gutter is only as good as its outlets. A gutter with too few downspouts overflows in heavy rain. A downspout placed where water cannot escape safely defeats the purpose of having a gutter at all.

Whether a house needs gutters in the first place is a separate question, and many houses here manage without them. Where water from the roof edge is not damaging anything, gutters and downspouts may add nothing but maintenance.

That decision, and how to make it during a replacement, is covered in rain gutters in Arizona. If gutters are added, the outlets are where the design succeeds or fails.

The City of Scottsdale homeowner guide names wind as the most damaging element in the southwestern desert. Downspouts and their extensions are exposed to it and are worth checking after storms.

Where to start

After the next heavy rain, walk the outside of the house and look at every downspout outlet. Note where the water went and what it reached. Look for erosion, staining, standing water and wet paths. That tells you whether your outlets are working.

If the roof is approaching replacement, raise drainage as part of the project. The cheapest time to move a downspout is when the gutters are coming down anyway. The wider context is in flat roofs, drainage and solar explained.

One safety point. Anything involving gutters means ladders and the roof edge, and the City of Scottsdale’s homeowner guide says roof work can be dangerous and lethal for the inexperienced. If your roof is due for replacement and you want drainage planned as part of it, Residential Roofing Scottsdale works across Scottsdale and the surrounding Valley. Call (480) 919-1173.

Frequently asked questions

These are the questions homeowners in this area ask most often about where roof water ends up once it leaves the gutters. Each answer is kept deliberately short, and the sections above go into more detail for anyone who wants the full reasoning before planning any work.

Where should downspout water go?

Onto ground that slopes away from the house, far enough out that it cannot run back, and somewhere it will not erode soil, flood a path or reach another structure. The right spot depends on the slopes and surfaces of the lot.

Can downspout water damage a foundation?

Water released repeatedly against or beside a foundation can wet and wash away the soil around it and stain or damage wall finishes near the ground. The damage builds slowly in the same place every storm.

Do downspouts need extensions?

Often, yes. An extension or splash block moves the outlet away from the wall and spreads the flow. Whether one is enough depends on the slope of the ground and what lies beyond the outlet.

Should downspouts drain into an underground pipe?

An underground line can carry water further from the house, but it can block with debris and silt and back up at the downspout. Any buried line needs a way to be checked and cleared, especially before the monsoon season.

How do I know my downspouts are in the wrong place?

Look after a storm for washed-out soil or gravel, channels running from outlets, staining low on walls, water standing beside the foundation, and wet or gritty paths. All of these are visible from the ground.

Is downspout drainage part of a roof replacement?

It can be. During a replacement the roof edge is rebuilt, so gutters and downspouts can be repositioned to where their water does least harm. We handle drainage only as part of a replacement project.